Post by Amorsolo Villanda on Dec 12, 2006 20:35:53 GMT -5
You may manually configure myGlobe Settings in your V3x by modifying the pre-installed Web Sessions. Here, we will do exactly the same thing we did for myGlobe. The only difference are the Parameters!
Let's begin!
1. Go to Web Sessions and Select ANY of the Pre-Installed Settings and select Options -> Edit.
2. Edit Each Fields with the Parameters Below. (Note: You cannot Edit the Web Session's Name - But that's not a Problem):
Smart GPRS Manual Config for Motorola v3x:
Let's say you selected Celcom WAP
Homepage: wap.smart.com.ph/3g
Service Type 1: WAP
Proxy 1: 10.102.61.46
Port 1: 9201
Service 2: WAP
Port 2: 9210
DNS 1: 000.000.000
DNS 2: 000.000.000
Speed: 9600
Line Type 1: Modem
Speed 2: 9600
Line Type 2: Modem
GPRS Application: smart1
*Click Done
Smart MMS Manual Config for Motorola v3x:
Let's say you selected Celcom MMS
Homepage: 10.102.61.238:8002
Service Type: WAP
Proxy 1: 10.102.61.46
Port 1: 9201
Service Type 2: WAP
Port 2: 9210
DNS 1: 000.000.000
DNS 2: 000.000.000
Speed: 9600
Line Type 1: Modem
Speed 2: 9600
Line Type 2: Modem
GPRS Application: mms
*Click Done
**Remember that you will need to set myGlobe GPRS as Default.
3. Now, go to Messages -> Options -> Setup -> Message Setup. Select Multimedia Message Setup and select Server Info.
4. You may see Maxim checked as your default MMS Server. We can change that and Name it to anything that you desire! Select Options -> Delete. Do this to delete all 3 Server Names under Server Info.
Note: At this Point, you should see Service1, Service2, and Service3.
5. Go to Options then Select New. Enter the following Parameters:
Service Name: anything you like
Server Name: 10.102.61.238:8002
Web Session: Celcom MMS (Remember that this is what you selected in this Example. This is where we manually configured the Smart MMS settings)
*Click Done
**Now your MMS should be all set!